As a widely distributed calcium carbonate raw material in the natural world, calcite has low milling production cost and high industrial processing value. The finished fine powder is widely used in various fields such as glass, ceramics, construction, chemical industry, and light industry. Currently, the domestic supply of skeletal powder is still in the “supply in short supply” stage, and the demand for calculus powder in each region continues to expand, so the investment prospects are particularly promising.
As the “status” of calcite powder has gradually increased, more and more investors have invested in the milling industry. Recently, friends have been consulted: How to configure the 500-ton calcite powder production line equipment? As a manufacturer of experienced milling equipment in the industry, FTM Machinery helps you resolve this doubt.
The basic configuration of 500 tons of calcite milling production line Equipment
Calcite powder, general fine powder requirements are about 40-800 mesh, the choice of raymond mill processing is just right, and the general calcite material is a large block, it can not be directly into the mill, there is necessary to first pass the simple crushing of the jaw crusher, and at the same time, it needs to equip the corresponding electromagnetic feeder, bucket elevator, classifier, dust removal equipment, etc.
- Raymond milling machine: The main equipment in the calcite grinding process, adopts three-dimensional structure design, strong independence, small floor space, high quality, sealed body, reduced dust noise pollution, and fineness of discharge. Freely adjustable in the 400-800 mesh range.
2. Jaw crusher machine: Core equipment for crushed calcite. Large feed capacity, high efficiency, uniform discharge, simple structure, long life, low failure rate, and affordable. It is better for the crushing equipment of calcite powder processing line select.
Secondly, the process flow of Nissan 500 tons calcite milling production line
- Crushing: The calcite ore enters the primary crushing in the jaw crusher to achieve the grindable particle size.
- Milling: The crushed stone block is sent from the bottom up to the silo by the bucket elevator, and then the electromagnetic feeder is evenly fed into the raymond mill for grinding, and the discharge granularity is adjusted as needed.
- Powder selection and collection: The calcite powder after grinding needs to be further classified by the powder sorting machine, and the finished calcite powder with higher purity and more standard is obtained, and then the finished product packaging can be unified by the powder filling tank car.